Recent content by claudej

Well nothing has worked. I got the 485 expansion board and put in the Aqualink pump works fine on any 485 connection heater does not. Ran a new cable to heater still nothing. I feel like a dip switch or a setting in the heater is off. I did not do initial install electrician for pool company...

Yes going to do this tomorrow it is raining now. I have a feeling one of the 485 cables is lose the way it acts

It forces cool down before switching. Now even after reset and power cycle I cannot get automation to control it at all. But I can use it manually. Again it says jandy remote mode on the display but remote automation cannot do anything. But yes it forces cooldown before it will flip the...

Yea I have it set to turn off the pump before switching modes but funny now that you mention it I believe the times I see it happen it is jot turning off the pump it will randomly switch without turning the pump off. Today it happened again I turned off the pier to the control board and heater...

New pool owner here from Florida. I was so glad to have found this site as reading others issues has helped me to troubleshoot and fix a few of my own equipment issues we have already found from our builder. Our original builder let us with a half build pool and we had to bring in someone to...

We just got our pool finished and I am having an odd problem with the heater and the automation system. The heater was working fine for the pool and the spa as it is combo system one heater for both. all works fine for a while and then. Was heating pool and working fine then switched to spa...