Recent content by chuck1971

Re: You guys have seen this before, Autopilot DIG-220 error You guys are awesome!!! Switched the pump setting and it started working. No idea how it got changed. I can here the fans running again... So, I did this last night. Checked it earlier today still good. just went out and it had...

Re: You guys have seen this before, Autopilot DIG-220 error Josh, thanks, not sure what I was doing wrong, but it worked this morning. OK, I change the cell to sc-60. It still shows the same 0 volts, 11.4 amps. The pump config is set to Remote runs pump. I have no clue what it has always...

Re: You guys have seen this before, Autopilot DIG-220 error I can't get into the installer menu. Trying to hold select as manual say be it does not work. WhAt screen shoul I be on when doing that???? Also noticed it thinks I have sc-48 cell and I have sc-60.

Re: You guys have seen this before, Autopilot DIG-220 error Ok, replaced cable and trisensor. Warning light is off but it is not producing chlorine. Test says salt at 2900, add 22 lbs. temp 84. Cell 0 volts 11.4 amps. Any ideas? I can't hear the fans running like I think I used to hear...

Re: You guys have seen this before, Autopilot DIG-220 error Thanks Sean. I was hoping you would respond. I will order now.

Re: You guys have seen this before, Autopilot DIG-220 error Of course, check it today and light is flashing same messages again.

Re: You guys have seen this before, Autopilot DIG-220 error Ok, removed manifold for 3rd time, reconnected cable for 22nd time, and it decides to work???? We will see, sounds from other posts as it may be short lived but it will save me some bleach at least for awhile! I will update if it...

Re: You guys have seen this before, Autopilot DIG-220 error I used a mirror to inspect the pins, all is good. I read on a post about the wire maybe getting hot or something and a goo coming out? I don't recall seeing this on my cable before. Any thoughts on this? Also read about sensor...

Re: You guys have seen this before, Autopilot DIG-220 error First, thanks for the response.... Cable has been disconnected and reconnected from both ends several times with no change in behavior. Cable physically appears ok. Is it possible to test the sensor or the cable to determine which...

Re: You guys have seen this before, Autopilot DIG-220 error BUMP

My SWG is 5 ohio pool seasons old. Getting a variety of error messages this year since I opened the pool. I am getting the Purifier OFF! No flow. Also getting the Warning bad temp sensor and sometimes getting the add salt xxx lbs. Flow is strong, clear valve seems to be working fine...

Bump.... I brought my pool to shock level for the past 48 hours to ensure that my cloudy water is not an algae bloom. With my light on my pool, the return line water leaves a "cloud" effect 4 feet wide or so. Still no ideas, but I still think it is air.

Thanks for the vaseline tip, of course I was told by a local pool supply store that it would work fine!!! The pressure is normal when the pump is on high, I run 22-23 psi. But, on low the pressure seems low, it barely is registering. It almost seems as if the pump is not functioning properly...

OK All, I inspected the lid o-ring, lubed with vasaline (till I can get a better lube) - Result No Luck I have a compression fitting between the top of the pump and the filter. Removed, cleaned, lubed, replaced -Result No Good I took off the top of the sand filter, cleaned, lubed, and...