Recent content by Chris J

I suspect that we are getting DE blowing back into spa. We just opened our pool this past weekend. The water in the spa seemed very cloudy. We thought it was because it had just been opened and the chlorine was not high enough yet. (It is a salt water pool). Water looked like it was clearing...

Is there any way to adjust the salt measurement indication on a Hayward Aqua logic system....... My aqua logic says the salt level is 3600 but a more precise measurement says the level is between 3000 and 3200

how often should the chlorine generator be cleaned

OK........ pulled the circuit board and low and behold the K1 relay solder connection was burnt. I soldered the connection, and replaced the 20 Amp fuse with a 15 amp fuse in order to make the fuse sacrificial instead of the relay connection. Everything and all diagnostic indicators are normal...

Switching polarity only works for a minute and then the same message appears....... chlorinator off High Salt/Amps. the minute it is on the diagnostics say 40.62 plus volts, 10.04 Amps, 87 deg, 1900 PPM. A more accurate salinity check shows its 3100-3200.

I found y'all while researching an issue with a Aqua Logic Goldline Chlorinator cell replacement. Replaced a T-15 with a T-15 and got the dreaded Chlorinator off, High Salt/Amp shutoff message. I found your thread on a resolution involving the K1 relay solder/connection by DJConn. Can...