Recent content by Cajun

Since you have a variable speed pump I would recommend a stenner pump over the liquidator. The liquidator needs to be set based on your flow rate and since you will be changing your flow rate it would be a challenge to get consistent results with one.

Thanks CA92807 for the writeup and thanks to everyone else for your help. My switches are controlled via software but I'll measure from the point where they are tied into the panel to determine what light or fixture has the issue. I suspect I will find both have a some leakage and the total...

I'll look at the wiring in the junction boxes. Could it be thats its a poor connection and this only triggers when both lights are on for some reason? That's the part that confuses me.

It's at least a 15 amp GFCI. The pool light is 500 watts and the spa is 100 watts. I can have everything else turned off and turning on just those 2 cause the gfci to trip. That should be under 5 amps so i dont think its an overloaded circuit causing this issue.

I'm having an interesting electrical problem and would like some guidance on where to look next. I have a gfci that is tied to several things. - pool light - spa light - grill outlet - other outdoor plugs installed by pool company Items I added to this same circuit. - outdoor led lights -...

For my last few bleach runs I have used Walmart's online pickup. You order online and schedule a pickup time. Show up and they load the bleach for you. The great value 8.25% is only $2.94 for 121 oz bottle. If you haven't tried it here is a link to get started. Walmart Grocery - Online...

I was excited about this until I ran the numbers, unless my math is off this looks to be higher cost for chlorine than store bleach. Here are the numbers I used Pool store $20 for 4 gallons of 12.5% vs Walmart at $2.94 for 121 oz of 8.25%. Looks like an oz of pure chlorine from the pool store...

Hello fellow prosper resident. I have been using a stenner for about 2 years now with great success. I would not hesitate to do it again. I usually get my bleach from walmart of target.

I used a 110 because for me it was just easier. I don't think there is an advantage either way.

Did you verify the black tubing was not cracked or split? This is one of the problems I had run into and I like you did lots of troubleshooting to figure this out. I would try a new tube if you have not already.

Re: liquid chlorine tank/pump installer in dallas-ft worth area oddly enough I bought my 15gallon blue tank from a place in Arlington I found on craigslist. its a really easy DIY install.

I went with the 3 gallon because i wired it to my pool controller and it only allows for 15 minute interval times. Just something you may want to consider depending on how you wire it up.

show us a picture with the waterfall on....

here is a 2 pack of tubes to make yours a 3GPD unit. Stenner #1 Pump Tube PK2 UCCP201 | Zoro.com

the 15 minute timer interval is the main reason I chose the 3 GPD pump (also i'm using mine for chlorine which is higher dosage than acid anyway). Changing the tube is very easy requires no tools and takes about 1 minute. The tube typically needs to be replaced ever year anyway. I would try...