Recent content by cagryinside

Thanks all for all the input, I was able to manage to fix the issue by adjusting the flow rate with the valves and the pump rpm. I directed most of the flow to jets and reduce the water going to these bowls, and slightly increased the pump rpm. As a result, I have smaller sheet flow effect on...

Thanks for the reply, I put plastic sheet underneath (see the attached pic), it worked but it looks pretty ugly. I will try a rubber band and report back.

Thanks for your response. I don't have the installation information. This is built 6 years ago by the previous owner. The problem started happening 1 month ago. I checked the level front end back. It looks leveled.

Thanks for the response, I put a level on it and it looks leveled. I have 2 level jandy motor, so problem happens in both low and high rpms. I tried to adjust the valves that control the water flow. But didn't make too much difference. I am not sure if there is other way to adjust the flow. For...

Hello, I'm a relatively new pool owner, having had my pool for about a year. Recently, I noticed that my pool spillover bowls started dripping water back onto the platform during the winter. I replaced the pool filter with a high-quality one, which temporarily resolved the issue for about a...