Recent content by Bullitz

Thanks, this put me over the top on the sand filter!

Ha! Sounds good!

Interesting! I'd like something that I can curve along the sidewall, but this gives me some ideas...thanks!

Ya, I wasn't sure if there was a way to create a stock tank pool "Section" of this forum. I'll take a closer look and see what I can do!

This is the type of thing we're talking about (not my photo)

It's 2' to the lip, but water level is roughly 5" below that. I would think I'd put the step at about 12" off the bottom. The whole tank is galvanized, and obviously being round presents it's own issues.

Thanks for your advice! My only question is that the sand filter pump says the minimum size pool is 2800 gallons, which is four times bigger than the 700 gallon stock tank. I have seen a video where a guy installed the sand filter, and it seemed fine. Why would there be a minimum pool size if...

Hi, I'm new to the group. My 8' diameter galvanized stock tank just arrived. I've found lots of DYI install information, but no forums to ask questions. My reason for posting is that I'd like to put a single step that can also be used as a sitting bench inside the stock tank. I have not...