Recent content by Brazillianguy

Let’s say 90 .. and my fill water is well water and not sure how to measure it. During the summer it rains a lot so not much filling with the well water . The question is more with current levels of my chemistry .. how the temp on 80 makes a difference in the CSI. Comparing from. Pool math and...

PH 8 (adjusted it to 7.6), FC 10, CC <0.5, alk 85, CYA 60 (need to raise it), CH 230. Current water temp is 73F but in summer it’s between 80-85 degrees

Would it make a difference if my CH is lower than the recommended? Because using the water wheel it would be a big difference if I use the recommended level

Hi everyone, with the ideal levels for my chemistry listed in the pool school, I noticed that that it doesn’t take into consideration my pool temp. With the Taylor water gram (the circle CSI dial) if I put everything in the ideal levels my pool temp would have to be 60-70 F. Where I live (Miami...

I think I’ve backwashed it a few months ago. The pressure gushes may be clogged. I know that my CC is <0.5 but will see about OCLT to confirm. Thanks !!

So during my regular weekly maintenance I noticed that the pump had a decent amount of air at the top. I went through some standard checks. I made sure the skimmer was clear, the water level was good. I tried to isolate the main drain and skimmer and the bubbles remain. I was afraid that I had a...

Can you show a picture of what you have for the CYA sock hanging device? I'm trying to figure out a way to adjustably suspend it front of the return jet Moved from here: CYA Sock Method

I wanna know the same.. what rigging people have done

Hi, So just wanted to ask for my clarification. So If I currently have a 1HP Single stage pump. I could get a Pentair Intelliflo VSF 3 HP ? Regardless of my filter? PVC tubing ? How would you determine the flow rate etc? So that it gets the right flow for the pool (filter etc) ?

Hi everyone. I currently have a Single stage Century pool pump and I have two questions about it. 1) I feel lately that the power isn't as strong as before. When I clean the pump basket and then restart it, I feel like the flow isn't as strong as it used to be. When it's priming it used to take...

How would you apply to ascorbic acid to the spot remover? Crush the Vit C and add water then place in the container?

Hi Everyone. I was wondering if anyone has had success using something like "Out Spot" by Purity Pools in order to place muriatic acid on a iron stain at the bottom of the pool. I currently have a Jandy Stain remover tool but I can't seem to get it to flow well out of the bottle into the tubing...

ohhh gezzz good luck..... wanna see the post

I just wanted a followup in case someone else is pulling their hair out trying to find the source of the airlock/bubbles. I'll post a pic of the repairs. I was just SO GLAD that the leak wasn't underneath the tile or the outside kitchen.. THAT would have been annoying!