Recent content by Bradly2osu

If I do that then the blower could run 10 hrs a day. Seems there’s gotta be another way.

So I have a few questions, first winter with new pool in north ga, (north Atlanta metro area) I have two pumps I’m going to winterize one that just runs my water descents, they are 4’ in the air and I feel it’s pointless to run them all winter. Just making sure I’m doing it right(I did have a...

I believe you’re right. The blower pipe is piped from Equipmemt underground to the spa about a 50’ run. The spa is elevated 6’ above the ground. I have not covered up any piping as of yet from equipment to about 25’ from pad. Since things are finished I’m trying to make sure it all works...

Well I messed with it a little today and the blower did come on. But I turned the blower on with the spa pump off. Prior to that I had spa pump on and turned the blower on and it worked the first couple times but the last time it did not and blower would start then just shut off. And not...

I have a 1-1/2 hp 240v silencer blower. Pool is new equipmemt hooked up in the last 2 months. I ran it it twice with blower worked fine. Now when I turn blower on it will come on then off within a 20-30 seconds. Sometimes I turn on from app or intellicenter panel and it doesn’t even turn...

Also just making sure the i8 would have 8 relays. I would need 2 for each pump, 3 for transformers, what else would take these as I’d have heater for spa, SWG which im assuming is on with the main pump, would the filter or anything else take a relay? Also in the future if I put up additional...

So I’ll have the intellicenter i8psic60 kit installed. So if I have the spa light controlled through 100 w transformer. 3 pool lights on another 100 w transformer then I could put landscape lights on a 300 w transformer all tied into intellicenter and the app should then be able to control...

So I have 4 pentair microbrite lights that will be installed. 3 in the pool and 1 in the spa. Do I need two transformers if I want to control the spa light separate from the pool lights? Say in the winter I just want the spa light on? But then in the summer would I still be able to cink all...

Ok lastly, as far as lights and blower I would assume to go with pentair as well so everything is the same or will other brands work with the automation on those specific areas. As far as my second pump that will run the water descents would you still go with a v.s pump at like a 1.5 hp or a...

So if I were to get an IC60 is that compatible with Jandy automation? The main Reason I ask is maybe the suppliers here all want to sell Jandy but every guy that ive talked to regarding equipment likes how Jandy’s warranties are with ease of use. They say all the equipment has issues but...

Ok. So there’s a pipe for pool drain and spa drain that are both stubbed up by pad. Also each skimmer is separately ran to the pad. So I should be able to pull off the main drain for a suction for a second pump. Yesterday I had another guy come out and look at and give me some ideas for...

So so looks like the 5 - 1-1/2” lines are all returns. Doesn’t look like there’s a suction for a second pump. Unless they put it in the spa but that makes no sense with How the pipes are aligned. If this is the case what is the best way to get suction to get another pump. These guys are...

Well good question, the pipes are not marked. So in the pool I have 3 - 1 1/2” for bubblers, There’s 5 - 1-1/2” pipes I’m assuming they are all returns maybe one is a suction? 3 are stubbed on side opposite of spa and 2 on the spa side. Then there’s 2-2” pipes at the floor of pool I was...

They were for labor only. With these items to be installed.