Recent content by belgique

  1. B

    Wedding Cake Step...need rails

    Found it! http://www.innovaplas.com/products/aboveground/MB00013/ Dang, the rails are $277 for the pair! Posting this in case someone else has the same problem.
  2. B

    Wedding Cake Step...need rails

    Hmmm. The PVC idea is a good one. Still hope to get the OEM ones. Thanks!
  3. B

    Wedding Cake Step...need rails

    The 2 rails on my wedding cake steps have corroded away and I'm trying to find replacements. There are no markings on the steps except: safety warning in French and English; Patent numbers; "Made in Canada"; and, perhaps most important, "Access Inc." I can't find Access Inc in pool stuff and my...
  4. wedding-cake-pool-steps-i12.jpg

    wedding-cake-pool-steps-i12.jpg

  5. B

    Pump Trips GFI

    Thanks Jason. I ran it unprotected (and no one around) for about 2 hours and then plugged in GFI and it ran perfect for about 10 hours and then tripped again. No rain in that time so something must be going bad inside so time to buy another one. Bought this in Jan and only used since April. Have...
  6. B

    Pump Trips GFI

    Pump less than a year old. It trips GFI's. I use plural because I have replaced the GFI and have plugged it into a different GFI circuit. If I plug it into a non GFI protected circuit, it runs fine. If I leave it on for an hour or so and then plug it into a GFI circuit, it does not trip the GFI...
  7. B

    Hayward T-CELL-15 No Current or Instantaneous Salt Numbers

    Re: Hayward T-CELL-15 No Current or Instantaneous Chlorine numbers My bad. I found this You Tube https://www.youtube.com/watch?v=tPL_YnvWumk and pulled the fuse (that I didn't know was there). Looked fine. I plugged back in and now have current and voltage. Suspect that I didn't have the plug...
  8. B

    Hayward T-CELL-15 No Current or Instantaneous Salt Numbers

    (Title wrong: Salinity, not Chlorine, fixed JasonLion) Just fired up the Haywood AquaRite for the season. Worked fine last year. Everything looks fine. It says it is producing...no flashing lights. But, there is zero for both the current and instantaneous salinity. Voltage is 30.3 which, per the...
  9. B

    Raleigh North Carolina area?

    I could have a friend dump some in and I see that some folks hang a container with pucks in the pool. From other reading, it would seem to not be a big deal if the water stays in the 50-60 deg area?
  10. B

    Raleigh North Carolina area?

    Following this also. Live on the Outer Banks and we almost never get a hard freeze. Impossible to cover because of wind. My question is if algae is a problem when the water is at, say, 40-50 degrees? We usually snowbird in our RV so it would be left unattended for several months. I have a...
  11. B

    Dummy T Cell?

    Thanks Jason! That helped me find it. Just bought one from Amazon http://www.amazon.com/Hayward-GLX-CELL-PIPE-Placeholder-Replacement-Generators/dp/B005IVZH4A/ref=sr_1_1?s=lawn-garden&ie=UTF8&qid=1344452446&sr=1-1&keywords=glx-cell-pipe
  12. B

    Dummy T Cell?

    Did I read here awhile back that there is a "dummy" T-Cell? Looking for something to put in-line when I remove the T-Cell for cleaning, winter, etc. Search didn't reveal anything for dummy. Thanks!
  13. B

    Topside Control

    Searching it seems that "Topside Control" is what spa folks call the thingy on top that shows the temp and where one makes adjustments and controls blowers etc. I didn't see any posts that address my issue. My panel works fine. It's just fogged over so bad that you can't read the temp or see...
  14. B

    Robot for Above Ground

    I went with the Dolphin Supreme M4. Expensive but love it. Enjoying the pool for the first time ever. I posted on another thread more detail. Scott: I have a Splash Super Pool and did not expect it to climb the wall because they curve inward. Surprising it does. It may not do it thoroughly but...
  15. B

    Pressure Vs. Robot

    I'm enjoying the pool (20x40 AG Splash Super Pool, 29,000 gal) for the first time since we've had it. I spent the last 5 years fooling with manual vacuuming or the useless Polaris turtle thing. Constant back washing to clear the filter hours a day and the stuff would settle back to the bottom in...