Recent content by almadillo

  1. A

    Going on vacation .... what to do with the pool?

    Thank you. I'm thinking of putting the solar cover on during the 2 weeks .... less dirt in the pool but also not able to clean it either
  2. A

    Going on vacation .... what to do with the pool?

    I live in North NJ. I plan on leaving late June / early July for a few weeks on vacation. I have a 35,000 gallon, in-ground salt pool. I am wondering what to do about maintenance while I am away. I typically skim it everyday, check chemistry every few days, and run the robot every few days...
  3. A

    Help to troubleshoot tripping breaker on Pentair EasyTouch

    Wow. The chips went in almost easily ... your guide is right ... the legs had to be bent inwards slightly. And I need better eyes as well .... And the board works again! No more tripping the relay breaker! Woo Hoo! Thank you both so very much for the advice and the guide. Saved me a lot...
  4. A

    Help to troubleshoot tripping breaker on Pentair EasyTouch

    I bought a pack of 10 ..... they were cheap and shipping is free. Thanks! Should arrive tomorrow. I'll post an update. Cheers! Alan
  5. A

    Help to troubleshoot tripping breaker on Pentair EasyTouch

    Well, both of you are correct. And thanks for the guide! One of the chips is causing the trip. Looks a little burned as well. (And looks like I did not put the other one in correctly ..... ) Now to get a new one and replace it .... any idea if I will need to reprogram the setup? Amazon...
  6. 20230707_101319.jpg

    20230707_101319.jpg

  7. A

    Help to troubleshoot tripping breaker on Pentair EasyTouch

    Thank you. I'll give it a go and see what happens. Alan
  8. A

    Help to troubleshoot tripping breaker on Pentair EasyTouch

    I have a pentair easytouch system ... it was installed about 5 years ago. The low voltage breaker which controls the relays keeps tripping. I have unplugged all the relays (there are 3 plugged in to the back of the circuit board) and the breaker still trips. I contacted pentair support who...
  9. 20230628_111538.jpg

    20230628_111538.jpg

  10. 20230628_111548.jpg

    20230628_111548.jpg

  11. A

    Power is out

    Us too. Been out since Tuesday. We do have a generator so I ran an extension cord to the pool and am using the pool cover pump to keep the water moving. Good Luck! Alan
  12. A

    Pentair ic60 not keeping up?

    Thank you. I'll try a SLAM when power returns (I live in NJ). No visible signs of algae. Chlorine is pretty stable also. CC is around 0.5.
  13. A

    Pentair ic60 not keeping up?

    Hello. I have a 35,000 gallon pool and run the IC60. I had it set around 90% to keep chlorine levels at 3-4. I did a water check at Leslies .... holy smokes my phosphates were at 4,000! After removing the phosphates (used Swimables Phosphate Remover X) and cleaning the pool/filer/IC60, I can...
  14. A

    No power - raise the chlorine or leave it be?

    My test CYA is 60 .... Leslie's test results are 54.