Recent content by AJB1234

Thanks. Are there any robots that are only 12 inches wide for fountains and negative edge troughs? The handhelds I've tried don't work great

I like the aiper x1 due to the ultra fine filter. Does the ultra fine filter need to be removed when cleaning walls? Looks like it may not be possible to run a floor and wall cycle with the ultra fine filters installed?

I can fill the water to the proper level to see the water halfway full in the window of the check valve. The check valve is definitely holding the water as I can tell The water level is not dropping in the window of the check valve. But when I fill The basket up with more water then I notice...

The face of the valve is just water. The pipe looks perfect. I cant figure out why it's not holding water. I fill the basket and can watch it go down. I have to fill it long enough where the water goes past the check valve and starts to back up. I can then get prime but once it turns off...

Here's a view that shows there is a second check valve but I don't think the check valve that's higher is the problem. It's challenging to even fill the basket with water because it takes forever and the check valve is very close to the basket so it should be a quick fill. Attached our pictures...

I'll check that out. B

Yes.

thanks. The back of the check valve as shown in the picture shows Hayward so I would think that would be the appropriate check valve to use. I do recall a different brand check valve at one location in the system but I'm not sure if it was for this fountain, a different fountain, or the pool.

I think everything is OEM. Here's a picture of the check valve that is not holding the water. I'm almost certain It is installed the proper direction. The water does flow up when the pump is on. When the pump is off or when it's running for a while, the water isn't holding drops below the window...