Water Level at Closing

[pb4uswim]

I have a Latham mesh safety cover. I cannot find the recommended water level is at closing. I know I’m not supposed to drain too much because the water is support for the cover if there is a lot of snow. I thought I found the recommended level earlier this year, but now I can’t find it. Any help would be appreciated. I’m starting to get my stuff together to close the pool - probably first week in October. I’ve already stopped heating the pool and am just giving it time to cool off before I fully close it.

Thanks.

 

[Mdragger88]

SafetyCoverInstallationManual.pdf

lathampool.widen.net

Hopefully this will help If you can zoom & read it -

 

[Newdude]

Looploc was 18 inches at one point and I drained 18. I'd still be draining 18 but we did a deep end bench that needs to stay covered. So I drain a foot and leave about 6 inches on the bench.

However far you choose to go, keep an eye on it and reset it back to low when it gets full again.

 

[pb4uswim]

SafetyCoverInstallationManual.pdf

lathampool.widen.net

Hopefully this will help If you can zoom & read it -

Thank you.

12 inches.

 

[Mdragger88]

I couldn’t get it to zoom clearly on my phone but I thought that’s what it said