Purchased an IC40 to go into my system run by my Intelliflo 3HP VS pump. I have a 6 foot straight run of 2 in PVC for the install area. The instructions discuss using a bypass loop when pump flow is going to exceed 80 GPM. 12 hours of the day my pump runs at 1450RPM, but weekly I run up to the full 3450 RPM for cleaning cycles which may drive flow up above 120GPM. In the winter, I will set the pump down around 750 RPM and run 23 hours. I'll pull the IC out and use LC during the winter. Would it be wise to put the IC on a bypass setup given the weekly cleaning rates of flow?