I have a Sta-Rite heater that has been hooked up for about 2 weeks and it's started acting up on me. I have an EasyTouch Controller that runs the pump, SWCG and the heater. I have the heater controlled by the EasyTouch via the fireman's switch. When I got the gas connected I threw on the breaker and it fired right up. After about a week, it stopped working so I opened it up and found that there was no power at the coil. Turns out the factory connector to the primary side had worked itself loose. I plugged it back in and used some cable ties to keep it together for good, put the heater back together and it started working again. The next day, it wasn't coming on again. By throwing the breaker to the heater on an off repeatedly it would come on, light up, then shut off, then it would come on and fire up then shut off then if you threw the breaker again it would come on and function properly, cycling on and off as the water temp called for it to do so. Pretty bizarre. Has anybody had this happen to them or heard of this happening? I will contact Pentair next week but if anybody has an idea what might be happening it will probably make the process easier.