sorry for a long question, just trying to give the info needed for a good answer/reply back.
i have a return flow question,
the past two days ive noticed after a couple hours, my return flow is low, hardly any flow pushing through.
when i take the cap (?) off of my pump where the basket sits, and release pressure, its fine for another couple hours.i am only loosening the top screw to the lid to get basket out/release pressure. not the one on bottom side.
i feel i am not doing it correctly as it should be full blast flow longer than a couple hours right?
ive looked in the manual to find troubleshooting for this, and did not see anything.
there is no debris in basket, and should not be in the lines as i use a pool cover all week, and was hardly any debris to skim. and my skimmer has been pretty clean/empty as well.
possible when i hung my cya by panty hose in front of the return some could have backed into it to cause clogging?
idk lol but thats whats going on with my return, and i shouldnt have enough debris to where anything is blocked.
am i releasing the pressure the wrong way?? any adv would be great, thanks
i have a return flow question,
the past two days ive noticed after a couple hours, my return flow is low, hardly any flow pushing through.
when i take the cap (?) off of my pump where the basket sits, and release pressure, its fine for another couple hours.i am only loosening the top screw to the lid to get basket out/release pressure. not the one on bottom side.
i feel i am not doing it correctly as it should be full blast flow longer than a couple hours right?
ive looked in the manual to find troubleshooting for this, and did not see anything.
there is no debris in basket, and should not be in the lines as i use a pool cover all week, and was hardly any debris to skim. and my skimmer has been pretty clean/empty as well.
possible when i hung my cya by panty hose in front of the return some could have backed into it to cause clogging?
idk lol but thats whats going on with my return, and i shouldnt have enough debris to where anything is blocked.
am i releasing the pressure the wrong way?? any adv would be great, thanks