I have a Hayward Power-Flo II pump with a MagneTek 1081 Pool Pump Duty 1.5HP motor and i have noticed that it appears the shaft seal is leaking. This would not seem like a costly repair to me, but I recently discovered that the motor's foot mounts as well as the bottom of the cover has rusted to the point that the feet have broken apart from the motor cover. The seal leak had not been too bad until yesterday when i tried to run the vacuum. The pump would not stay primed with the vac and hose attached with the filter in waste or filter. I finally gave up and reprimed the lines and started the system back on normal operation. I believe that the pump losing prime made the seal leak worse, and it is now leaking profusely. When assessing this damage, i then realized that the motor cover and foot mounts had rusted heavily to the point that the foot mounts are no longer holding the motor secure to the base. With all this in mind, can and should i try to get new seals AND chase down a replacement motor cover, or should i just buy a new pump and be done with it. My wife and i are actually trying to sell this house so i want to make the most cost effective decision. Thanks for any advice.