While researching VS pool pumps, i have found quite a few references to problems with the drive electronics, to the point where some folks reject VS because the electronics fail due to vibration and cannot be repaired.
To me the solution is obvious - remove the drive electronics from the pump, put it on a wall nearby, and replace the 6 inch cable to the motor with a 6 foot cable or conduit.
I am a complete newbie, so please tell me what is wrong with this idea - 'cause i suspect it would have been done if it worked.
I do not know a lot about variable frequency drives and motors, but i work among a lot of them, and in no case is the drive electronics mounted on the motor housing.
Just and idea . . .
To me the solution is obvious - remove the drive electronics from the pump, put it on a wall nearby, and replace the 6 inch cable to the motor with a 6 foot cable or conduit.
I am a complete newbie, so please tell me what is wrong with this idea - 'cause i suspect it would have been done if it worked.
I do not know a lot about variable frequency drives and motors, but i work among a lot of them, and in no case is the drive electronics mounted on the motor housing.
Just and idea . . .