I got a fairly new motor and pump assembly for my 2001 Viking Supreme hot tub. At first I was able to turn on the light and switch between low and high speeds. Now that I over filled the tub until it ran across the switch on top of the tub, I can't get nothing but the filter cycle when I put the power to the tub. It will also heat the water in this cycle. From the factory the filter cycle stays on for 5 hours every 12 hours. Does anybody have any idea's to what is wrong here. I do have a slight leak on the suction and the output side of the pump. I did switch the red and black wires on the 240 volt system, hoping it would run on the high speed during the filter cycle. No.......that didn't work. Any help out there?