- Sep 14, 2010
- 6
Hi. I just purchased a jandy cl 580 filter to replace my Hayward s220t sand filter which I thought was just too small. I have a sta-rite 1 HP dura-glas pump.
My question is how to plumb the pump to the inlet of the cartridge filter. The inlet is only 10" off the ground whereas the pump exit with an elbow would have to be at least 16" high.
Would you advise to raise the filter ~6" off the pad with some pavers or bricks or plumb it by adding 2 extra 90 degree elbows. Connections will be 2" PVC.
36k in ground pool
1hp sta-rite pump
Jandy CL580 cartridge filter
Most plumbing 1 1/2" PVC
My question is how to plumb the pump to the inlet of the cartridge filter. The inlet is only 10" off the ground whereas the pump exit with an elbow would have to be at least 16" high.
Would you advise to raise the filter ~6" off the pad with some pavers or bricks or plumb it by adding 2 extra 90 degree elbows. Connections will be 2" PVC.
36k in ground pool
1hp sta-rite pump
Jandy CL580 cartridge filter
Most plumbing 1 1/2" PVC