I've just purchased a Pentair EasyTouch 8 load center (without SCG) and doing some research before tackling the install. I've read many of the previous threads about wiring one up and just wanted to confirm a few things. My current power from a sub-panel has 2 legs of 240V running to the timers, and 1 leg of 120V running to the pool/spa lights.
My equipment is Pentair Intelliflo main pump, (2) Pentair Whisperflo pumps for waterfalls, Booster pump for Polaris, Starite natural gas heater, Glacier GPC 210 45 GPM Chiller.
My first question is for breakers in the EasyTouch. What besides the pool lights are required/need to be on a GFCI breaker? I was reading a post earlier that recommended to wire the Intelliflo up directly to the breaker and the COM port instead of the relay. Should my Intelliflo be on a GFCI breaker and if so, is this true for the rest of the pumps?
Thanks in advance for any help.
My equipment is Pentair Intelliflo main pump, (2) Pentair Whisperflo pumps for waterfalls, Booster pump for Polaris, Starite natural gas heater, Glacier GPC 210 45 GPM Chiller.
My first question is for breakers in the EasyTouch. What besides the pool lights are required/need to be on a GFCI breaker? I was reading a post earlier that recommended to wire the Intelliflo up directly to the breaker and the COM port instead of the relay. Should my Intelliflo be on a GFCI breaker and if so, is this true for the rest of the pumps?
Thanks in advance for any help.