Aqua-Trol SWG
Led display is working, but only partially, the last 2 numbers are either faint/hard to read or missing a "black dash". I opened the panel and LED, pins & board look clean.
Just downloaded the Diagnostic manual and it goes over steps to check for No LED display. If mine is a partial display would the checks for the transformer, rectifiers or DSP Boards be the same & could I tell the bad part ?
what's a good place to order replacement ?
thanks
Led display is working, but only partially, the last 2 numbers are either faint/hard to read or missing a "black dash". I opened the panel and LED, pins & board look clean.
Just downloaded the Diagnostic manual and it goes over steps to check for No LED display. If mine is a partial display would the checks for the transformer, rectifiers or DSP Boards be the same & could I tell the bad part ?
what's a good place to order replacement ?
thanks