New pool owner. Have been lurking a while. First post! We purchased an Intex 18x52” round XRT pool. We are having a hard time with our set up, mostly getting the bottom of the liner to lay in a circle & smooth bottom wrinkles out. My son noticed the stitching in the seam of top sleeve support was off and changes at a point . I attached a picture of the stitching and one of the pool set up where the fabric near the far left pole looks “short” like there isn’t enough in that area, same area close to where the seam changes.
Do I have a defective liner? Or is the uneven seam common and it will most likely straighten out with the water? We’ve only put a little in it so far, at the wrinkle smoothing stage (twice!) Any advice would be greatly appreciated!
Do I have a defective liner? Or is the uneven seam common and it will most likely straighten out with the water? We’ve only put a little in it so far, at the wrinkle smoothing stage (twice!) Any advice would be greatly appreciated!