Hi Friends,
Just bought a house with a pool a week ago, over my head in the set up.
It's a Nature2 Fusion Soft and in the iAqualink app it is giving me Check AquaPure (No Flow). I assume this means my pool isn't producing chlorine.
Jets seem to be working fine in high speed and low speed. Skimmer basket cleaned. PSI of about 16. AquaPure is set to 30%. Salt is 3300 PPM. These are all settings the previous owner had. Water temperature is 67F (not sure if that matters, someone told me it has to be a certain temperature to produce chlorine).
Do I need to clean my filter cartridges? Is there a reset button on a "daughter panel"? Clean the sensor? Replace the sensor?
As I said, complete newbie, photos would be SUPER helpful or very clean instruction.
Thanks so much.
Just bought a house with a pool a week ago, over my head in the set up.
It's a Nature2 Fusion Soft and in the iAqualink app it is giving me Check AquaPure (No Flow). I assume this means my pool isn't producing chlorine.
Jets seem to be working fine in high speed and low speed. Skimmer basket cleaned. PSI of about 16. AquaPure is set to 30%. Salt is 3300 PPM. These are all settings the previous owner had. Water temperature is 67F (not sure if that matters, someone told me it has to be a certain temperature to produce chlorine).
Do I need to clean my filter cartridges? Is there a reset button on a "daughter panel"? Clean the sensor? Replace the sensor?
As I said, complete newbie, photos would be SUPER helpful or very clean instruction.
Thanks so much.
