After much work and worry over the Memorial Day weekend, my liner is in and pool is up and running. Only had one instance of liner coming out of track during install and had to pump out about 4 inches of water to get it down so I could put it back in the track (beaded liner). Actually used a plastic spatula like you get with a Foreman grill to help with making sure the bead was back in the track.
I cut in the skimmer (much anxiety over this) with no problem. Return went in without issue also, at least until I started the pump. I have a bit of a leak on the outside at the return. Not really bad, just a couple of drops a minute. Should I go ahead and drain and replace gasket, or will this be ok for a while? My concern is that water is also leaking behind the liner, which would probably not be good?
Any thoughts or suggestions greatly appreciated!
I cut in the skimmer (much anxiety over this) with no problem. Return went in without issue also, at least until I started the pump. I have a bit of a leak on the outside at the return. Not really bad, just a couple of drops a minute. Should I go ahead and drain and replace gasket, or will this be ok for a while? My concern is that water is also leaking behind the liner, which would probably not be good?
Any thoughts or suggestions greatly appreciated!