- May 3, 2021
- 24
- Pool Size
- 10000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-30
Hello all
I am getting ready to open my pool. Today I disconnected my pump so that I could lub the O-rings. I can not get the O-rings to stay in their grooves during reassembly. The suction side one mostly stays in place, the one on the discharge will not stay in the groove. Any suggestions
Thanks
I am getting ready to open my pool. Today I disconnected my pump so that I could lub the O-rings. I can not get the O-rings to stay in their grooves during reassembly. The suction side one mostly stays in place, the one on the discharge will not stay in the groove. Any suggestions
Thanks