Yes that is with the new kit.I'm going to do the test again tonight to make sure the results matchIs this results from the new test kit? Bring down ph first to 7.2 before you start slam mode. You might have to add acid more than once. 8.2 is highest it reads so it may be higher. Test in 30 mins and dose again if necessary to get it down.
Ok can't wait to get this done. Wife gave me till the 4th
I would check the CH number, just to know. Low CH is no problem. High CH can still cause scaling, even in a fiberglass pool. And you can't attack it with a wire brush. You might need to drain some water to lower CH, and in that case, don't waste time or chemicals treating water you'rte just going to dump.Ok so this is what I got from test
Chlorine is 0
Cya is 40
Ph is 8.2 or above
Ta is 60
It's a fiberglass pool so I didn't do calcium I can if it's important
Do I need to drop the ph or use the calculator and start bleaching
Just plug in the strength. Most likely it's 8.25% The bottle sizes only matter when you're talking jugs.Quick question about great value it's 121oz but says same amount as 182oz. Do I go off of the 182 amount