Well... First the site has been very helpful, but my first post on here.I'm out here in Yuma, Az. It's hitting the 100's and I just took over duty on a 197,000 gallon pool here on the Army base. It is a SWC pool. They fought all last summer to keep the chlorine in it. I found the stabilizer was non existent in it.Salt content is dead on. I got the chlorine readings up to 5.0ppm....Too high they want it at 3.0ppm. They shut down the pool today and I'm looking for quick advice. I cant figure out how much neutralizer to put in the water without killing all my work. All my tests and chems are dead on but they want it at 3.0ppm. I need it open quickly. I have tried searching charts,etc which got me here to TFP. Any suggestions, time is not on my side at this point? Thanks in advance,Mark