(1) So I have this second pump a Pentair 2VST, that is attached to my EasyTouch 8. But I cannot control it. It looks like they wired directly to the breaker instead of an AUX or other controller.
This pump is solely for my waterfalls and bubblers. I have a electronic valve between the two directions of pipe (one to bubblers, one to waterfalls).
(2) I can get the valve to turn 180 degrees either only bubblers or only waterfalls, but not in between without manually stopping it by turning it off. I have designated the valve to Aux 5, and defined Aux 5 as a spillway, so I thought that would cause it to stop at 90 degrees where both could run at same time. But it doesn't work.
My questions are, (1) since I do not have a spa, can I wire the pump to the Spa controller, so it acts like a spa pump where I can control speed, etc. and (2) if I then designate the valve to the spa, can I control it so that it opens one, the other or both (three positions) as spillway?
Hope that makes sense.
thank you in advance!
This pump is solely for my waterfalls and bubblers. I have a electronic valve between the two directions of pipe (one to bubblers, one to waterfalls).
(2) I can get the valve to turn 180 degrees either only bubblers or only waterfalls, but not in between without manually stopping it by turning it off. I have designated the valve to Aux 5, and defined Aux 5 as a spillway, so I thought that would cause it to stop at 90 degrees where both could run at same time. But it doesn't work.
My questions are, (1) since I do not have a spa, can I wire the pump to the Spa controller, so it acts like a spa pump where I can control speed, etc. and (2) if I then designate the valve to the spa, can I control it so that it opens one, the other or both (three positions) as spillway?
Hope that makes sense.
thank you in advance!