i've got a new hayward swimpure plus and pushing the diagnostics button does NOTHING. the display is stuck on water temp.
is the button broken? is there any setup/reset process?
is the button broken? is there any setup/reset process?
From the manual
Diagnostic Displays
Be sure to have the following information
Sequential pushes of the small "diagnostic" button next to the LCD display will cause the Swimpure RJ to display the following information:
1. Pool temperature (degrees Fahrenheitor/Celsius)
2. Cell voltage (typically 22.0 to 26.0 volts when chlorine is being generated ,other-wise 30-35V)
3. Cell current (typically 2.50 to 4.00 amps when chlorine is being generated, other-wise 0 amps)
4. Desired Output % ("0P" -- "100P" depending on knob position )
5. Instant salinity (-xxxx ppm or -x.xx grams/Liter)
6. Product name sent to the display ("AL-6" signifies "Swimpure" (STD), ("AL-7 signifies "Swimpure RJ Return-Jet")
7. Software revision level (r1.xx)
On the 8th push of the button the display will revert back to the default salt display. Also, if the button is not pushed for 30 seconds, the display will revert back to the standard salt display.