Hello!
I have a hayward heater that is showing CE when booting, then switches to SF quickly. I have read that it could be the temp sensor, but my temp sensor is plugged into my Prologic 4 system and is reading the correct temperature. It is my H250 that is showing the error. I was going to replace my temp sensor, but I don't know if that is a waste of time based on the CE error. Any advice would help!
Also, I tried to move my heater from "bo" mode back to manual to test if its the connection to the prologic, but the SF error won't let me do anything on the board.
Thanks!
BK
I have a hayward heater that is showing CE when booting, then switches to SF quickly. I have read that it could be the temp sensor, but my temp sensor is plugged into my Prologic 4 system and is reading the correct temperature. It is my H250 that is showing the error. I was going to replace my temp sensor, but I don't know if that is a waste of time based on the CE error. Any advice would help!
Also, I tried to move my heater from "bo" mode back to manual to test if its the connection to the prologic, but the SF error won't let me do anything on the board.
Thanks!
BK