Hi all, just getting ready to put my AGP walls up tomorrow (I'm BEAT) and at the last minute I decided to get some cove (to give my old bones a break) and the gorilla pad to help against the rocks.
So:
- regarding the cove, I have a Sharkline Matrix and on the inside at the upright the boot extends further inside than the track, this forces out the coving and it dosn't really fit nicely, should I just trim/cut the back of the coving a bit so it fits better??
- also on the coving, each piece is the same length as the distances between uprights, so should I place the cove ends between the uprights and not right at the uprights? Putting the edges at the uprights seems like it will make an inferior join, especially in light of the above point
- regarding the gorilla pad, the pool is 20' and the pad is 21', should I cut the pad a bit? How far up the sides of the cove can the padding go?
Thanks for this site, I've learned so much. When the pool is up (hopefully tomorrow) I'm gonna pay my dues and join up, this site has so much info.
So:
- regarding the cove, I have a Sharkline Matrix and on the inside at the upright the boot extends further inside than the track, this forces out the coving and it dosn't really fit nicely, should I just trim/cut the back of the coving a bit so it fits better??
- also on the coving, each piece is the same length as the distances between uprights, so should I place the cove ends between the uprights and not right at the uprights? Putting the edges at the uprights seems like it will make an inferior join, especially in light of the above point
- regarding the gorilla pad, the pool is 20' and the pad is 21', should I cut the pad a bit? How far up the sides of the cove can the padding go?
Thanks for this site, I've learned so much. When the pool is up (hopefully tomorrow) I'm gonna pay my dues and join up, this site has so much info.