I have ScreenLogic 2 and Pentair VSF. I have a built in spa with a spill over. In settings I checked freeze protection for my pool and spa but it is not cycling. It goes in spa mode and stays there. Any ideas what could be causing this?
Freeze protection not cycling
- Thread starter tjk65
- Start date
- May 3, 2007
- 16,963
- Pool Size
- 20000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-15)
What does the controller report as the air temperature when it should be cycling?
What is the controller freeze temperature threshold setting?
What is the controller freeze temperature threshold setting?
- Jul 17, 2019
- 3,719
- Pool Size
- 13000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Are you in Service Mode by chance? That will override freeze protection settings until you exit Service Mode.