Flow Switch or Something Else?

[Winter247]

Moved from HERE

I'm having this same issue, however, mine is a brand new pool. Seems unlikely that the flow switch would be bad out of the box. I know that water flow is fine and the filter is clean. I confirmed there's no interlock setup for it. I was also able to deactive the system shutting down due to the "no water flow" alarm via service mode configuration, but I still need an actual solution. I did this pool as an owner/builder so it's on me.

 

[Jimrahbe]

247,

If you can feel good flow coming back to the pool at one of your returns, then it is a problem with the flow switch or circuitry..

Make sure the flow switch is not installed backwards.

Thanks,

Jim R.

 

[ajw22]

Check that the flow switch connector is fully seated in the jack on the OmniPL board.

Use a multimeter continuity check to see if the Flow Switch opens and closes.

Check the two middle pins on the connector.