We had a leveling company come in to level a couple of PCs of concrete around our pool. This was supposed to be a simple job. They made a mistake on one section and raised the concrete over an 1” above the copping side which goes up to Flag Stone. In stead of stopping, after one section seeing the damage, they went all the way down the side, leaving a dangerous sharp edge. (About 20+ ft) We now have to remove all of the stone and mortar and have it reset HOW do we keep all of the debris out of the pool. They will have to work from the top.
Flag Stone Copping Damage/now the mess
- Thread starter ToniDav
- Start date
- Jul 21, 2013
- 52,665
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
Float a vinyl tarp on the water alongside the pool wall and tape the tarp to the wall.
The tarp will capture any large debris that falls into the pool.
Pull the tarp out daily and dump the debris it catches.
Your filter and pool cleaner will work overtime keeping up. What equipment do you have?
Float a vinyl tarp on the water alongside the pool wall and tape the tarp to the wall.
The tarp will capture any large debris that falls into the pool.
Pull the tarp out daily and dump the debris it catches.
Your filter and pool cleaner will work overtime keeping up. What equipment do you have?
Thank you for your response. We still can't believe they didn't stop seeing the damage continue. I will get that ready. Our system is about 20 years old its a starlight