Dead Hayward Aqua Rite PCB?

[wkusae31]

Hey everyone. My battle with my SWG continues. The problem is that there is no power light, no generating light, but there is a no flow light when the pump is first turned on. It also gives the diagnostic readings.
2800, 82, 14.6, 0.00, 68P, - 0, AL - 0, r 1.59, t-15

I've replaced.

1. New salt cell
2. New board

Is my PCB bad or what else can I do?

 

[JamesW]

Make sure that the jumper is set to the correct voltage.

 

[JamesW]

Hayward Aquarite SWG - Further Reading

www.troublefreepool.com

 

[wkusae31]

Hayward Aquarite SWG - Further Reading

www.troublefreepool.com

That did the trick! Awesome advice! The power is now on but the NO FLOW light is continuous and so is the INSPECT CELL. But it's a brand new cell.

 

[JamesW]

It looks like a bypass is open?

 

[JamesW]

Reset the average salinity.

 

[wkusae31]

It looks like a bypass is open?

It goes from flashing No Flow to Generating (for about a minute) and then goes to solid NO FLOW and INSPECT CELL.

We've had the valves in same position since we opened on 5.12.23 so I'm kinda lost.

 

[JamesW]

The valves are not set correctly.

The cell is really not even in the correct place.

What do all of the lines go to?

 

[JamesW]

 

[wkusae31]

It finally worked when I reset the chlorine. It may have been the switch that was stuck in an in-between position. Your help has been absolutely incredible. Thank you so much for your time and wisdom. You have no idea my frustration these past 7 days.

As for the valves, I didn't build the pool so I'm not 100% sure but the valve in the middle (lower red circle) is supposed to be the heat pump bypass (from what another TFP expert told me a few weeks ago). The top valve (top red circle), I have no idea. But water is flowing to pump and coming out the eyeballs. The chemistry of the pool is balanced so I'm assuming the valve openings are ok, but it's just an uneducated guess.

 

[JamesW]

You should figure out all of the plumbing and make sure that everything is working properly and verify that the flow switch is also working.