The liner guy was supposed to change the light with the liner. It's a 12 V 300 watt light. It must be in about 50 ft of conduit back to the transformer. It must make a 90 bend somewhere. He could not get the wire to pull back through the conduit so he could replace the light. They really should have used a bigger conduit. He had two guys tugging on it as hard as they could. They got worried that they might damage something and gave up. The whole works is covered in concrete. I could probably dig down a couple of feet and then over about 6 ft and get to it. I'm hoping you guys might have some ideas about this predicament.
Any cool tricks that you can share?
Any cool tricks that you can share?