I replaced new Omnilogic MSP display because the old one display screen was died. I uploaded config settings from USB to new MSP. When I checked every items setting in config wizard, I can't find relay listed for filter pump, heater, light post, ect. Anyone knows why this happened? Did I do anything wrong?
can't find relays in config wizard after Omnilogic MSP replacement
- Thread starter dennic hu
- Start date
- Jul 21, 2013
- 53,762
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
No, I think the firmware may not be the same because I updated firmware in the new replaced MSP remotely and then downloaded backup config from usb. Do you have idea what I can do to fix the problem?
- Jul 21, 2013
- 53,762
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
unfortunately the new MSP still can't find relays after I reset the MSP to factory settings. is it because filter pump, fliter and chlorinator are discounnected during pool closing?