I have an older Autopilot (Navigator) that is working fine except that the Tri Sensor Cable just went bad at the connector to the flowmeter (a couple of the wires pulled out of the connector)
I can’t seep locate a replacement cable (it is not the same connector at the motherboard as the current cables available)
I know the color coding at the motherboard
red - white = Flow
brown - green = Salt
black - Blue = Temp
Does anyone know the pin outs at the other end of the cable? (connector at the Flow Meter (18124 Rev B)) so I can repair the cable.
OR
Does anyone know where I could get either a replacement cable
Any help would be appreciated
I can’t seep locate a replacement cable (it is not the same connector at the motherboard as the current cables available)
I know the color coding at the motherboard
red - white = Flow
brown - green = Salt
black - Blue = Temp
Does anyone know the pin outs at the other end of the cable? (connector at the Flow Meter (18124 Rev B)) so I can repair the cable.
OR
Does anyone know where I could get either a replacement cable
Any help would be appreciated