I just received my TF-100 and got the results of my first test. New pool owner and have a SWG that was completed in June of this year. I'm located in the Dallas Texas area.
Results:
FC - 9.0
CC - 0
PH - 7.8 (I add about a gallon of muratic every 10 days since pool was built, have never seen it below 7.4 yet).
T/A - 140
CH - I messed this test up but I believe it to be on the high side (according to my strip test). I need to redo.
CYA - 60
My main concern is my high chlorine. I believe it's been this high for a while. I have all new Jandy equipment and run my Aquapure at around 60%. My variable pump runs at middle RPM range (1750 rpm) around 13 hours per day. 2 hours it runs higher for cleaner.
Does my process sound reasonable and should I be concerned about high chlorine? Now that it's cooler I was going to reduce my pump to around 10-11 hours per day. My water looks very clear and clean from day one.
Thanks
Results:
FC - 9.0
CC - 0
PH - 7.8 (I add about a gallon of muratic every 10 days since pool was built, have never seen it below 7.4 yet).
T/A - 140
CH - I messed this test up but I believe it to be on the high side (according to my strip test). I need to redo.
CYA - 60
My main concern is my high chlorine. I believe it's been this high for a while. I have all new Jandy equipment and run my Aquapure at around 60%. My variable pump runs at middle RPM range (1750 rpm) around 13 hours per day. 2 hours it runs higher for cleaner.
Does my process sound reasonable and should I be concerned about high chlorine? Now that it's cooler I was going to reduce my pump to around 10-11 hours per day. My water looks very clear and clean from day one.
Thanks