- Apr 25, 2011
- 19
I purchased a home that came with a 24'x48" above ground pool. The pool was empty and the liner has deteriorated. The previous owner was nice enough to cut 3 slits in the sides approximately 8-10" long (darn it!) It also has a center drain installed which I assume should be removed for safety reasons. The sand base looks good and the foam cove is in place. No logos are apparent to identify the manufacturer of the pool either.
I am hoping that I can repair the damage to the side of the pool, install a new liner, pump and filter and enjoy the pool. ( the pump and filter were taken by previous owner.) How should I patch the sides properly?
I am seeking advice on how to proceed with the repairs. I appreciate the help!
ps: If I can figure out how the resize photos to 256k, I will post them. thanks!
I am hoping that I can repair the damage to the side of the pool, install a new liner, pump and filter and enjoy the pool. ( the pump and filter were taken by previous owner.) How should I patch the sides properly?
I am seeking advice on how to proceed with the repairs. I appreciate the help!
ps: If I can figure out how the resize photos to 256k, I will post them. thanks!