I had to take apart the pump to put in a new shaft seal. The leak is gone but now the motor will only run on low even when I switch to high speed any ideas?
tHANKS,
Dennis
Ok I figure it out. It appears while I was holding the shaft with the wrench I must have broke one of there two arms which causes it to not hit the contact point. Now where do I get it or do I need the whole thing? Here are some pics
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!