First of all, my pool pump has ~30psi and that routes through the heater, chlorinator and ends at the caretaker head. By the time it gets there it is ~12psi. I think that is the main problem that I have. Should there be more pressure there? Is there anyway to get that higher?
Then, I have the five head system and each section has 4-5 heads on them. The heads don't fully pop-up as they would if they were out of the pool. Some sections work completely fine, while others (further from pump) don't really work well. They pop-up partially and get stuck up and sometimes don't rotate. I just replaced all of the heads on the pool this week and I'm having these issues (which was ~$1100).
Any thoughts or ideas or anything that can help fix my pool?? I'm hoping to get this working really well so the pool stays clean and I don't have to go buy a robot.
Then, I have the five head system and each section has 4-5 heads on them. The heads don't fully pop-up as they would if they were out of the pool. Some sections work completely fine, while others (further from pump) don't really work well. They pop-up partially and get stuck up and sometimes don't rotate. I just replaced all of the heads on the pool this week and I'm having these issues (which was ~$1100).
Any thoughts or ideas or anything that can help fix my pool?? I'm hoping to get this working really well so the pool stays clean and I don't have to go buy a robot.