Hi to all,
I have a Tagelus TA60 with clearPro since 2 years and alaways had a hard time besause of high pressure (25 psi -27 psi after 5-10 minutes backwash and 45 sec. rinse).
When running in recirculate mode, pressure is around 12 psi.
Is it normal a 15 psi difference between recirculate and filter for this type of filter?
If I fill with gravel + sand should it reduce pressure?
Even new it was running at minimum 24 psi.
Please help me because of high pressure I need to backwash everyday because heather stop to work with the flow error message.
Here is my equipment:
Superflo 1.5 HP
Tagelus TA60 with clearPro
Summit SUM 3 heat pump.
Thanks.
I have a Tagelus TA60 with clearPro since 2 years and alaways had a hard time besause of high pressure (25 psi -27 psi after 5-10 minutes backwash and 45 sec. rinse).
When running in recirculate mode, pressure is around 12 psi.
Is it normal a 15 psi difference between recirculate and filter for this type of filter?
If I fill with gravel + sand should it reduce pressure?
Even new it was running at minimum 24 psi.
Please help me because of high pressure I need to backwash everyday because heather stop to work with the flow error message.
Here is my equipment:
Superflo 1.5 HP
Tagelus TA60 with clearPro
Summit SUM 3 heat pump.
Thanks.