Hi, new to the forum. Last summer I was gone a few days and noticed the pool starting to turn green. When I checked the panel, the generating light was off and the inspect cell and check salt were lit. I searched the net and found a recommendation (possibly on this forum) to replace the current limiter/varisitor so I did and I was up and running again. Now, once again the generating light is off and the inspec cell and check salt are lit. So, I once again replaced the current limiter (had ordered a couple of spares) but this time it didn't fix the problem. When first turning on the control panel the generating light will light and everything appears good but after about 30 seconds it goes off and the inpect cell and check salt light up. So, I tried it one more time with yet another replacement current limiter (thinking that maybe the other one could of been bad from the factory) but no luck, same problem.
Any recommendations would be appreciated.
Any recommendations would be appreciated.