I have a Hayward Salt Machine (Smart Control 2) and I am getting a reading that says "Water Sensor Shortage". How do I repair that? Currently the machine will not read the temp of the water but is still giving my salt level.
There’s a temperature sensor in the plumbing somewhere. Most likely it has failed.
The part you need is probably the Hayward GLX-PC-12-KIT 10K Thermistor Temperature Sensor. Find it in the plumbing and follow it into the automation box.
Turn off power to the system and disconnect the two wires. Test resistance through the sensor and compare ohms to temperature in 10 K thermistor chart.
If ohms don’t match temperature, replace sensor.
Don’t do anything that you’re not sure that you can do safely.
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!