relay

Hello! My omnilogic boots up intermittently, typically after a 24 hour period shut off. Once (if) it boots all the way back up, it will run for roughly 72 hours and then fault out. If I hard reboot it immediately after failure, by turning off the 120v power, it will sometimes boot to...

We have a Pentair EasyTouch 8 control system for our in-ground pool and exactly as another post back in 2016 had happen... this past weekend, following a fairly severe electrical storm, the Intellichlor salt generator was not working. When I investigated I found that the problem was that the low...

I have a few extra omron relays for my compool et upgrade setup. I use a Jacuzzi JSCS-40 on AUX7 so I can schedule its startup and shutdown (usually 1/2 hour after the pump is scheduled to start and before shutdown). Im thinking of introducing a flow switch on the low voltage side, basically...

We received an email telling us to update our Omnilogic firmware. After many attempts, to download the upgrade via the USB and Internet we were able to download all of components except to MPP. After calling Hayward their first question was to get hte serial number and notify us it was outside...

I recently upgraded my 20+ Jandy JI8000 to an Aqualink RS. That went great. This year one of the relays stopped working for my main pump. I have it working with my spa relay, but I will be changing the relay. When I upgraded the Jandy unit, I did not change the relays. They are a different...

Does anyone know the part number or name of the Red 2 & 3 Pin Connectors on the Aqualink RS Boards? A mouser or digikey partnumber would be cool. Thanks

So the pump is not shutting off from the control panel , even in Service mode, I can hear a click but pump continues to run. My home warranty apparently cover only the pump and wiring :mad: not the actual controller so I figured out that must be a relay becauise everyhting else works just fine...

Album Link with Diagram and short demo video: https://photos.google.com/share/AF1QipPePNtaRleoPiGWqiSO6MFvwp_aetOlRAMRII-YXtbrvU1AdmA879ONrODEBQw-2A?key=c2YxRDhjTkx4RUpvbEFpUzRtQ1lDSThsZHhTREV3 Using a SONOFF 4CHPROR3, I have integrated the control of my Filter Pump, Booster Pump, and two Jandy...

Hello all. Just had my pool completed and have installed an Omnilogic control system. I have a simple standard 120v spare barn light that I would like to install over the pump. Just looking for some light for late night clean out etc. Question: Can I just hook this up to one of the spare...

Good day everyone. What a great resource this forum and site has been overall. Thank you. I mounted up and wired the Pentair EasyTouch 8p, one body of water, no spa. I have 3 12V pentair lights, a Pentair 011018 IntelliFlo Variable Speed filter pump, a Pentair 011519 WhisperFlo water...