Search results

Gotcha. I did tighten with a wrench so maybe that's my issue. I'll double check the oring and then hand tighten it. I'll also apply some lube which I didn't do.

I recently had to replace the bottom part of my Pentair Cartridge Filter. After reconnecting the existing inflow and outflow PVC to the filter housing, I have a small leak on one of the two connections. Does anyone know if I can use some kind of sealant to shore up that connection and stop the...

I am assuming the CircuPool RJ-16 will be sufficient for my 6600 gallons ?

I'm in! Calling my installer first thing in the morning. Had a SWCG with my last pool but was talked out if it by my pool builder on my current pool.

Finally got my CYA level down to around 55 after drain and fill of around 6000 gallons. Now using liquid chlorine to get my FC level up. Anybody see a reason I shouldn't covert to SWCG now?

Yes it is close, with the exception of the spotting.

None up close where you can see the plaster. I was actually out of town the week of plaster and pool fill. Only have distance pics after the fill.

Water exchange underway to remove excess levels of CYA. We've had several inches of rain this week so I imagine some exchange has already taken place.

They are stored inside at the highest, 73 degrees.

I was wondering when someone was going to ask that question. They are a year old and will replenish soon. I was thinking this could be causing my numbers to be wacky.

My fill water has a pH = 7.5 if that makes a difference. I'll post updated numbers soon.

Thank you. I will attempt a pool water exchange over this week following the previously stated guidelines.

For those asking about possible pool leak, according to attached photos showing a 24 difference, it doesn't appear that I have a leak. Auto fill was turned off during this time as well.

I think I noticed subtle changes last year some time during the summer.

Makes sense, thank you. So my pool water is 78F and fill water is 75F, not that much difference. Where do you recommend the sump pump be (deep or shallow) and the fill water be (deep or shallow) ? It will be raining here over the next couple of days, so I imagine the pool temp will drop a few...

What do you mean by "Don't drain unless you can verify that it is safe to do so." ?

To get my CYA down, I plan on a partial drain this next weekend and refill. I will test before and after.

Ok, 3-1 dilution gets me about a 65 CYA reading.

I have the TF-100. I did perform the CYA dilution test by mixing a cup of pool water and a cup of tap water. The result was 100. Assuming the CYA is high because of the tabs I've been using.

Installed June/July 2018 and my water bill is not unusually high. Probably plastered in July. I've turned off the auto fill and will report the 24 hour difference tomorrow.

Ok, I've turned the chlorinator on to a trickle but there's not much in there at moment.

I've turned off my auto fill and inline chlorinator a few minutes ago.

We have gotten some good rain over the last week. Would this affect my numbers in anyway?

Here are my fill water numbers ... FC = 1 CC = 1 CH = 25 TA = 150 CYA = 0 PH = 7.5