Search results

Our 18 year old diving board was not looking great. At first I tried spraying it with appliance epoxy, it looked great but was very slippery when wet even with the existing grit still there. Next I tried a matte finish boat deck paint with added grit, and it was still slippery when wet. My final...

I have to replace a cracked drain cap on my Hayward st310t2 tank. With the filter pump off, how much water is lost with a quick swap of the drain cap?

I will check it. The booster pump is new as well, so maybe it's taking in some air from there.

Setup is the same as the old. As for the floating it seems to be air in the system. I can submerge it and it will fill up and sink, but then an hour or two later it is floating again. The Polaris hose near the connector and connector gets covered with air bubbles. Which is strange since I do not...

I'll try that, but so far every other source says it is discontinued and no longer available.

Our Polaris 380 was 18 years old and overdue for replacement. I purchased anew 380 and a new Polaris booster pump. I am having 2 issues with the new 380 that were not happening with the original one. 380 primarily stays in the deep end. It will climb the slope towards the shallow end but ends...

Unfortunately I do not have pictures from when it was leaking. I did a quick drawing describing the leak. For close to 2 weeks it was wet on the concrete in front of the tank base as shown in blue. From about half way back on the filter. I drilled a 2" hole in the back side of the base and it...

I replaced both our Polaris 380 and pump with new ones after 18 years. I trimmed the hose as per the instructions and made adjustments that appear to have it cleaning properly. The only issue is that is gets itself tangled up at the connection in the pool wall. I had never had this issue with...

A couple weeks ago I noticed what appeared to be a leak from the bottom of our 18 year old Hayward ST310T2 sand filter tank. There was water coming from under the base. I used a hole saw and put a 2" hole in the base and confirmed it was wet under the tank. I talked to my pool guy and he said...

I tried that site, but the add to cart is greyed out and you cannot add it.

Looks like the motor is discontinued. Anyone know where I could get one, even a working used one? I really don't want to pay $750 to replace both lights with the LED replacement kit. Thanks in advance.