Search results

Oh there's loss of water. I patched it last winter and it held. I loose about an 1/8" overnight. Thanks. I found three companies in my area that do the work. Are the new finishes any good? I've seen the Pebble Tech and a few others on YouTube.

Hello all. I have a 22 year old gunite pool that has two cracks and i think needs to be replastered. I live in the south east (Charlotte) and was wondering when is the best time to get the replastering, crack repair, and tile work done. Is there a time of year that's cheaper than another? Also...

Forgot to post. I turned the rpm's down on Spillover mode and that corrected the problem.

The 1st one. (next to the filter pump)

Aux 3 is vacant as per the instructions whne flipping the 3rd dipswitch to on. Thanks

I just installed/upgraded to iAqualink3 and replaced my dead pump with a VSPF. I flipped the 3rd dipswitch on the Jandy board to enable spillover. The issue now is that my air blower now also turns on when the spillover is on. Any ideas on how I can correct this behavior?

Thanks guys.

Ok, thanks.

Ok thanks. So you'd recommend cutting over shimming up the Pump?

Hey all. I just bought a Pentair Intelliflo3 VSF to replace my Hayward Northstar. After removing the Northstar it appears that the intake line doesn't match up. That being the case should I just shim up the pump with a piece of pressure treated lumber, or cut the lines and lower them? I have...

I will now.

Any brand specifically?

Ok. GFCI breaker right?

Ok thanks.

Ok. I have an old version currently will be upgrading it next month to this. My pumps bearing are going so I need a new one stat. Try this link.

Would you recommend this one?

Ok thanks.

Is there a list of compatible pumps someplace? Is this a compatible pump?

I am about to purchase a Hayward TriStar VS model W3SP3206VSP. I currently have a older rev Jandy automation RS8 system. In doing my research of the install document here it appears that I can use the cleaner (not free on my system currently), and the solar actuator ports. My question is if I...

I dont have the iaqualink. My system is old school.

Probably not as its 20 years old and hasn't been updated. I ended up getting a new 2 speed pump. Now I'm trying to figure out how to make it run in low speed by default. created another thread about that.