Search results

  1. S

    Hayward H350FD troubleshooting

    So my heater won't light. Typical IF code. Pulled the orifice tube and cleaned orifices. They were spotless clean. Pulled each burner tube and inspected. Baffles have some corrosion but flame holes look great. Removed loose scale. Pulled ignitor and tested, gets red hot. Pulled flame sensor...
  2. S

    Serial Number??

    Where can I find the serial number on the Pentair Warrior SE?
  3. S

    Doheny Discovery Help

    When I run the self test on the robot, ( lay on its back outside of the pool it should run 10 seconds forward and then 10 seconds backwards and then shutdown) it will run forward for a few seconds then stop and then continue to run forward again and not stop. In the pool it runs around for about...
  4. S

    Help Troubleshooting Hayward Heater

    I have a Hayward H350 connect to a Jandy PDA Aqualink. I have no error codes and the display reads as it should (bo & standby as connected to Jandy). When switched to low speed or pump off the display changes to LO as it is supposed to do. When I turn the heater on I can hear the relay in the...
  5. S

    Repair Polaris 9300 or Purchase new Doheny Discovery

    So I have a Polaris 9300 that is about 5 years old. One of the first generation models as I never had any wheels break off or any other problems that others have noted. Started giving me blinking light problems and would only run the long cycle no matter which button was pushed. Leslies...
  6. S

    Should I be concerned about Cracks

    Our Gunite Pool is approaching 5 years old now with Wet Edge Pebble plaster. At the end of last swim season I noticed some fairly large cracks in the pebble plaster at the deep end of the pool. 2.5 ft long and large enough to put a ball point pen into the crack in some areas (1mm I guess). I...
  7. S

    Calcuim Hypo Tablets

    Why is it that the only brand of Cal-Hypo tablets I can find locally is at Wal-mart in the HTH brand? I know you can get the AccuTab online, but I figured through the pool stores & or other areas, tablets would be available. I'm needing to raise my CA while lowering the CYA and thus, wanted to...
  8. S

    Low Hardness Issues???

    My pool is about two years old now and we really we have been enjoying it. Understanding the BBB method has made taking care of the pool so easy, and the water looks great. From the research I read on the forums most people tend not to worry to much about low CA, as it tends to creep up on its...
  9. S

    Best way to clean Coping & Grout?

    First Swim was yesterday after heating up for about 1/2 day, :D. Added Borates the day before and water is sparkling once again;). So I have a light Travertine coping with antique white grout. In several places I have black mildew (I assume) in the grout lines. What is the best way to...
  10. S

    Water Autofill Dirty??

    Is it common for the water in the autofill float area to be dirty? I pulled the cover off just recently and the water was not very clean. I suspect over the winter the water was stagnat for a long time as the filling was not required. Not that summer is here the autofill will be filling the...
  11. S

    Algae in Pebble Pool Question

    Our pool has Wet Edge Satin Matrix in the Northshore Carribbean color. The pebble contains a moderate amount of black pebbles as well as tan and blue. I have seen smooth white plaster pools with algae before, but never a pebble pool. Isn't if very difficult to see the algae with so many...
  12. S

    New Weber Grill

    So early last year I started doing research on grills as I knew we would be investing in one sometime in the near future. I had picked out the Weber S-670, which is their 6 burner top of the line grill. At this time the economy had just sunk and the price on the grill was around $1,500 the...
  13. S

    Acid in new Pool, bleached plaster?

    So on start up of the pool the PB added 4 gallons of Muratic Acid to my green water while the pump was running by walking around the pool and pouring the acid in straight out of the bottle. Since then I have been trying to keep pH under control and adding acid as well while the pump is running...
  14. S

    Electrical Question

    They did a 360 perimeter ground (bare #6 copper) tied to the deck rebar and carried it back to the equipent pad. Attached it to each piece of equipment and then terminated it on my end pump motor. Shouldn't it leave the end pump and then go into the control box to the ground bus? The pump has...
  15. S

    Polaris 9300 or TigerShark

    I'm torn between these two and need help deciding. I have two friends who have the tigershark and are happy with them. However the Polaris appears to be abit more attractive in functionality and it comes with a cart. The Polaris is more expensive, (thus leading me to believe it may possibly...
  16. S

    New Build in SE Texas

    Thanks TFP for all the valuable information. :-D Well we are suppose to close on our financing this week. Hopefully we will be digging before the Holiday weekend. :party: Specs are: 102 ft Perimeter, free form Depth 3.5- 7.5 ft Tanning Ledge w/ 3 gushers Coping: Natural Stone, upgrade from...
  17. S

    Screen Enclosure Foundation

    I intend to have a screen enclosure installed possibly next year after the pool is built (hopefully next month or so, waiting on bank for closing). Our deck area/screen enclosure will be 36' X 47'. (Also, fyi the quote for the screen is around $22K, which I thought was reasonable given the only...